Vape Cartridge artwork — for distributors
If you are comparing three quotes for vape cartridge, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
Published 06 November 2024 · VapeWholesaleHub · Reading time 8 min
Quality control, in plain terms
We ship vape cartridges to distributors, chain buyers and independent shops. What follows is the material we normally cover in a first conversation: what we hold in stock, how we test it, how it ships, and what happens when a carton arrives damaged.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
How we structure a first order
The first question we ask is not what you want to spend. It is what your customer already buys. Answer that and the vape cartridge list writes itself; skip it and you end up with a pallet of stock that photographs well and sells badly.
We keep a short list of approved configurations for vape cartridges. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.
Labels, closures and traceability
Regulation for vape cartridges differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
- Mixed SKU cartons to spread first-order risk
- Private label files archived for future rebrands
- Standing reorder schedule with a fixed cut-off
- Seven-day defect reporting with replace-or-credit
- Reference sample retained from every batch
- Consolidated or split shipping, quoted both ways
Keeping the second shipment identical
Reorders are the real test of a supplier. If the second shipment does not match the first, the relationship is over regardless of price, so we treat the reorder as the actual deliverable.
We keep the specification sheet for every order on file. Two years later, when a customer asks whether a pod is compatible, the answer is a lookup rather than a guess.
Specification summary
| Volume | 0.5 ml |
| Core | Ceramic |
| Resistance | 1.5 ohm |
| Thread | Press-fit |
| Airflow | Bottom |
| Packaging | Blister |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 18 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
How do you handle repeat orders?
The specification is held on file against your account, so a reorder is a reference rather than a new brief. We recommend a standing schedule with a fixed weekly cut-off so stock lands before the shelf empties.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz