VapeWholesaleHub  |  Wholesale supplier · Shenzhen, China
Tel / WeChat / WhatsApp: +86 13711127975  |  vape@0099933.xyz
Home  /  Vape Cartridge  /  Vape Cartridge contract and PO terms for the EU market
vape cartridges · convenience store chains

Vape Cartridge contract and PO terms for the EU market

Vape Cartridge is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.

Published 03 September 2025  ·  VapeWholesaleHub  ·  Reading time 5 min

Surface finish under raking light, one of the cosmetic checks.
Surface finish under raking light, one of the cosmetic checks.
Vape Cartridge contract and PO terms for the EU market configuration from a production run, photographed before packing.
Vape Cartridge contract and PO terms for the EU market configuration from a production run, photographed before packing.

The checks behind every shipment

Buyers come to us for vape cartridge after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for convenience store chains.

A 0.5 percent defect rate sounds excellent until it lands on a 600 unit order and you are handling three returns in a week. We quote realistic rates per category and we credit in advance for the known failure modes.

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Unit price versus landed cost

Currency moves more than most buyers expect over a twelve month supply plan. We quote in USD and hold the price for 30 days from confirmation so your margin calculation is not guesswork.

We publish a realistic band of 1.77 to 5.42 per unit for standard configurations at 50 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.

For convenience store chains, the practical answer is usually a shorter range: two core lines, one step-up, one trial SKU. Everything else is inventory risk wearing a nice finish.

What your market will ask for

Advertising rules are stricter than product rules in most markets. Claims about cessation, health or comparative performance should stay off packaging and off your product pages unless your legal team has signed them off.

Labels are where good orders go wrong. Nicotine warnings, child-resistant closures, batch coding and market-specific text all have to be correct before the pallet leaves. We prepare test reports, declaration of conformity and safety data sheets for each shipment and we ask for your destination list early so artwork matches the market.

  • Standing reorder schedule with a fixed cut-off
  • Specification locked in writing before production starts
  • Cartons drop-tested and pallet-counted for clean freight
  • Reference sample retained from every batch
  • Mixed SKU cartons to spread first-order risk
  • Seven-day defect reporting with replace-or-credit

Turning shelf space into repeat visits

Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.

Shelf position decides velocity as much as price. Keep vape cartridges at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.

Specification summary

Typical specification for this category
Volume2.0 ml
CoreCeramic
Resistance1.5 ohm
ThreadPress-fit
AirflowBottom
PackagingBlister
Minimum order200 units per SKU, mixed cartons allowed
Lead time18 working days after artwork approval

We would rather lose an order at quotation stage than explain a mismatch after delivery, which is why the specification conversation comes before the price conversation.

Frequently asked

What is the minimum order for vape cartridge?

Standard configurations start at 50 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 200 units because of setup time on the line.

What documents come with a shipment?

Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.

How long does production take?

Around 30 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.

Related reading

Need a quotation on vape cartridges?

Send destination market, target price and quantity. Same-day reply on working days.

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz

Talk to the supply team

Ask for a quotation on vape cartridges

Tell us the market you sell into and the price band you work in. You will get a specification and a landed cost estimate, not a catalogue dump.

What to send

Destination market, target retail price, quantity per SKU, and whether you need private label. With those four lines we can quote the same day.

Samples ship by air express and the cost is credited against your first production order.

Email the team
WhatsApp Email us