Vape Cartridge CRP small batch guide
We work with convenience store chains who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Published 21 February 2026 · VapeWholesaleHub · Reading time 8 min
The reorder is the real test
A vape cartridge programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.
Every account gets a named contact who has actually seen the product. Being passed between three people to answer one question about a coil resistance is the fastest way to lose a buyer, so we do not organise support that way.
For private label accounts we hold the artwork files and the approval record. Rebranding a line eighteen months later is then a file update instead of a redesign.
What we test before a carton is sealed
A 0.5 percent defect rate sounds excellent until it lands on a 600 unit order and you are handling three returns in a week. We quote realistic rates per category and we credit in advance for the known failure modes.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
How the price is actually built
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
Unit price breaks usually land at 300, 800 and 1600 pieces. Between those steps the cost curve flattens, which is why pushing a 200 unit order to 500 often costs less per unit than buyers expect.
- Named account contact who has handled the product
- Artwork proof plus physical dummy for custom packaging
- Private label files archived for future rebrands
- Document pack prepared per destination market
- Standing reorder schedule with a fixed cut-off
- Reference sample retained from every batch
Presentation that earns the step-up
Bundle a device with a consumable and the reorder rhythm changes from occasional to weekly. That single merchandising decision often does more for monthly revenue than a price promotion.
Shelf position decides velocity as much as price. Keep vape cartridges at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Specification summary
| Volume | 0.5 ml |
| Core | Ceramic |
| Resistance | 1.5 ohm |
| Thread | Press-fit |
| Airflow | Side |
| Packaging | Blister |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 22 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How do you handle repeat orders?
The specification is held on file against your account, so a reorder is a reference rather than a new brief. We recommend a standing schedule with a fixed weekly cut-off so stock lands before the shelf empties.
What is the minimum order for vape cartridge?
Standard configurations start at 300 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 800 units because of setup time on the line.
Related reading
Need a quotation on vape cartridges?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz